Kitchen Plumbing & Fixture Installation in Brooklyn, NY

Kitchen plumbing work covers a wide range — installing a new sink and faucet, relocating a sink to a new spot in the layout, running a gas line for a range, hooking up a new dishwasher, and dealing with the low water pressure and old cast-iron stacks common in Brooklyn's older buildings. All of it is performed by licensed master plumbers we work with regularly, not general labor doing plumbing work off to the side.

Older Brooklyn buildings bring specific plumbing realities that a suburban new-construction plumber doesn't necessarily encounter often: original cast-iron waste stacks that are still in service after a century, upper floors with noticeably lower water pressure because of how the building's supply riser was originally sized, and, since a 2020 city law took effect, periodic gas piping inspections under Local Law 152 that can surface issues during a remodel that weren't obvious before.

Any work that involves a gas line specifically requires a licensed master plumber and a permit, plus a final inspection before gas service is restored — there's no shortcut on this, and we handle the filing and inspection scheduling as a standard part of the project.

Plumbing work also has to be sequenced carefully against cabinets and countertops — supply and drain lines need to be roughed in before cabinets go over them, and final connections happen after countertops are set — so we schedule it as part of one coordinated timeline rather than as an independent job that other trades have to work around.

📞 Call (689) 358-3644

Request This Service

* Indicates required field

Other Services

Sink and Faucet Installation and Relocation

A straightforward sink or faucet swap in the same location is usually a same-day job. Relocating a sink to a different spot in the layout — common when a galley kitchen is being reconfigured or an island is added — means running new supply and drain lines under the floor, which is more involved work and, depending on scope, may require a permit. We scope the difference clearly at the proposal stage so there's no confusion about why moving a sink costs meaningfully more than replacing one in place.

Gas Line Work for Ranges: Licensing and Permits

Any gas line installation, relocation, or connection for a range must be performed by a licensed master plumber and filed with the city, with a required inspection before the gas company will restore or connect service. This isn't a step we skip or shortcut under any circumstances — improperly done gas work is a genuine safety hazard, and it's also something that surfaces at resale if it wasn't done to code and permitted properly.

Dishwasher Hookups in Buildings With Older Supply Lines

Some of Brooklyn's older co-op buildings historically restricted dishwashers because the original plumbing risers weren't sized with the additional water and drain demand in mind — a real, if increasingly outdated, concern in a number of prewar buildings. Before installing a new dishwasher, we check your unit's supply line capacity and your building's rules (some boards still require notification or approval for a first-time dishwasher install), so you're not left with a dishwasher that overtaxes old plumbing or violates a proprietary lease.

Dealing With Low Water Pressure on Upper Floors

In taller Brooklyn buildings, especially older ones without a booster pump system sized for modern fixture demand, water pressure on the top floors can be noticeably lower than on the ground floor — which affects everything from how your new faucet performs to how a dishwasher or ice maker line functions. We check actual pressure at your unit before finalizing fixture selection, since some faucets and appliances perform poorly below a certain minimum pressure.

Working Around Cast-Iron Stacks and Old Risers

Many Brooklyn buildings still run on original cast-iron waste stacks, which can be a century old and, while often still functional, sometimes show scaling, reduced diameter, or corrosion when we open up a wall near them. We inspect the condition of any stack or riser we're tying into and flag it if it looks like it's approaching the end of its service life — information worth having even if a full stack replacement is outside the scope of your kitchen project.

Local Law 152 Gas Piping Inspections and Your Remodel

Local Law 152 requires periodic inspection of a building's gas piping system on a rotating borough-wide cycle, and a kitchen remodel that involves gas work can sometimes intersect with where your building sits in that cycle. If your building's gas piping inspection turns up an issue unrelated to your specific remodel scope, it's worth knowing about before your project starts — we'll flag this possibility during planning if your building's inspection cycle is coming up.

Garbage Disposals: Where They're Allowed and Where They're Not

Garbage disposals are legal to install in New York City but many co-op buildings still prohibit them in the proprietary lease or house rules, largely because of concerns about older waste stacks handling the additional load. We check your building's specific rules before including a disposal in the plan — it's a quick confirmation that avoids installing something your board doesn't actually permit.

Permits and Inspections for Plumbing Work

New supply or drain lines, any gas work, and significant fixture relocations all require a plumbing permit filed by a licensed master plumber, plus a scheduled inspection before the work is signed off. We handle this filing as a standard part of the project scope and keep you informed of inspection scheduling, since it's often the one part of a plumbing project's timeline that depends on the city's schedule rather than ours.

Water Filtration and Instant Hot Water Add-Ons

Under-sink water filtration and instant hot water dispensers are popular add-ons we install alongside a sink or faucet project, particularly for clients unhappy with their building's tap water taste or mineral content. Both tie into your existing supply line with a dedicated small tap at the sink and don't require a permit on their own, making them an easy addition to fold into a larger plumbing scope rather than a separate project.

Vent Stack Requirements When Relocating a Sink

Plumbing code requires an adequately sized vent connecting to the drain near any relocated sink, which prevents slow draining and sewer gas from entering the room — it's not optional, and it's one of the more common things an unlicensed renovation gets wrong. In a lot of older Brooklyn buildings, tying into an existing vent stack in a reasonable distance is possible, but sometimes a new vent line has to be run, which affects both cost and how much wall or ceiling has to open up to install it correctly.

Kitchen Plumbing & Fixture Installation FAQs

Can I install a garbage disposal in my Brooklyn apartment?

Garbage disposals are legal under NYC code, but many co-op buildings still prohibit them in the proprietary lease or house rules over concerns about older waste stacks. We check your specific building's rules before including one in a plan.

How long does gas line work take from permit to final inspection?

It varies with the city's current permit processing time, but plan for the licensed plumber's filing, the physical work itself (often one day for a straightforward range gas line), and a scheduled inspection before the gas company restores service — typically a few weeks total when everything goes smoothly.